Hach sc1000 Profibus DP/V1 Manuel D'utilisation De Base page 11

Description (continued)
Option
STATUS Status— Indicates the Profibus network card status
• Please wait: is shown until the network card has found all
configured slaves or is displayed when the card is new
configured and is searching for sensor connections
• PLC configure err: is shown when the network card has
received a wrong configuration of a PLC (Programmable
logic controller), e.g. write to a read only variable.
• Ready: is shown when the network card is ready to send
data to the Profibus. Check the address and/or the wiring.
• Online: is shown when the network card is in contact with
PLC and cyclic Data is sent
INPUT FROM Datalog Intervl: setup the data log interval.
PLC
Meas Units: Enter a name for UNIT and PARAMETER
Note: A new or initial telegram configuration could take several minutes!
Depending on the number of sensors, the STATUS shows "Please wait".
English
8