Mounting The Dash L.e.d. Indicator; Mounting The Valet Toggle Switch; Mounting The (2) Relays - Audiovox TSP-575 Guide D'installation Et D'utilisation

3. Mounting The Dash L.E.D. Indicator

Select an area on the dashboard or center console that will provide the
most visibility from all angles outside the vehicle ( driver's window,
passenger's window, rear window, etc. ).
IMPORTANT ! Make sure there is adequate room for the body of the
L.E.D. behind the panel in the selected location. You should also be sure
that the drill will not pierce any wires, or damage other components after
passing through the panel. It is always best to remove the panel from the
vehicle before drilling the hole.
To mount the L.E.D.;
A. Drill a 1/4" diameter hole at the selected mounting location.
B. Pass the L.E.D. wires through the hole from the front of the panel, and
press the body of the L.E.D. into the hole until fully seated.
L.E.D.
DRILL A 1/4" DIAMETER HOLE

4. Mounting the Valet Toggle Switch

Select a flat area on the lower dash lip, where the switch is readily
accessible to the driver, but will not be accidentally bumped. Other
alternate locations are on the driver's side kick panel, or the side of the
lower steering column cover.
Since this is a " protected " ( will only operate when the key is in the
ignition ) bypass switch, it does not have to be concealed, however
concealing the switch is always recommended, as this provides an even
higher level of security to the vehicle.
IMPORTANT ! Make sure there is adequate room behind the panel for
the body of the switch in the selected location. You should also be sure
that the drill will not pierce any wires, or damage other components after
passing through the panel. It is always best to remove the panel from the
vehicle before drilling the hole.
To mount the valet bypass switch;
A. Drill a 9/32 " diameter hole in the selected switch location.
B. Pass the switch through the hole from behind the panel, and secure
from the front using the split lockwasher and hex nut provided.
TOGGLE SWITCH
SPLIT LOCKWASHER
DRILL A 9/32" DIAMETER HOLE
Page 2
5. Mounting the ( 2 ) Relays
The relays can be mounted in the engine compartment, but it is best to
mount the starter cut relay in the passenger's compartment, where it will
not be exposed to the environment. The relay that will be used to disable
the vehicle's starter should be mounted close to the wires coming from
the ignition switch. The relay that will be used to flash the vehicle's
parking lamps should be mounted near one of the front parking light
clusters.
To mount the relays;
A. Screw the relay to the mounting surface, using a sheet metal screw
through the hole in the relay mounting tab.
B. Secure the relay to an existing wire harness or other component using
cable ties.
MOUNT INSIDE
PASSENGER'S
COMPARTMENT
HEX NUT
WIRE TIE TO EXISTING
HARNESS IN VEHICLE
SHEET METAL
SCREWS
RELAY
RELAY