Intended Use; Technical Specifications - Matrix DWS 600-1 Traduction De La Notice Originale

When choosing grinding disc, please observe the
manufacturer's specifications. The sand paper
beyond the grinding block leads to risk of cutting
and injury and cause stuck as well.
11. .The machine can be connect to one
extension tubes at most.
12. We recommend that you always wear
industrial safety gloves and safety goggles when
working with the drywall sander.
13. Wearing close-fitting clothes is mandatory.
14. Always allow for reaction torque
15. Wear protection mask P2 to protect you from
hazardous dusts and choose suitable vacuum
cleaner.

INTENDED USE

The intended use of this power tool is the
sanding of large areas of drywalls as a
preparation before painting or wallpapering
using suitable abrasive sheets.
This power tool is neither suited for the
preparation of small areas, corners and edges,
nor for the removal of wallpaper and the
grinding of ceilings and wet grinding.
Do not use the power tool for cutting or
roughing or polishing. Do not use it together
with wire brushes. Do not treat
asbestoscontaining
materials with this power tool.
This power tool is solely intended for private
use. Do not use the power tool for any other
purpose than for the intended one. Any other
use beyond the intended use is improper.
For any resulting damage or injury, the user/
operator is held liable, not the manufacturer.

TECHNICAL SPECIFICATIONS

Reference
Nominal voltage
20
Input power
No-load speed
Platen diameter
Output shaft screw thread
Acoustic pressure level L
Acoustic power level L
Level of vibration
NOISE/VIBRATION INFORMATION
Measured sound values determined according to
EN 60745.
Wear hearing protection!
Vibration total values (triax vector sum)
determined according to EN 60745:
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in EN
60745 and may be used to compare one tool
with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level represents
the main applications of the tool. However if
the tool is used for different applications, with
different accessories or poorly maintained,
the vibration emission may differ. This may
significantly increase the exposure level over the
total working period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched off or when it is
running but not actually doing the job. This may
significantly reduce the exposure level over the
total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organization of work patterns.
DWS 600-1
230-240 V ~ 50 Hz
600 W
600 – 1500/ min
210 mm
M6
85 dB(A), K = 3 dB(A)
pA
96 dB(A), K = 3 dB(A)
WA
a =3,18 m/s², K = 1,5 m/s²
h