Matrix DWS 600-1 Traduction De La Notice Originale page 17

a) Do not force the tool. Use the correct tool
for your application. The correct tool will do the
work better and safer in the conditions for which
it was manufactured.
b) Do not use the tool if the switch does not
make it possible to change from the operating
condition to stop and vice versa. Any tool
which cannot be controlled by the switch is
dangerous and should be repaired.
c) Disconnect the power cord before any
adjustment, changing an accessory or
before storing the tool. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
d) Keep idle tools out of the reach of children
and do not allow persons unfamiliar with the
tool or these instructions to operate it. Tools
are dangerous in the hands of untrained users.
e) Maintain the tool. Check that there is no
misalignment or obstruction of the moving
parts, broken parts or any other condition
that could affect the operation of the tool. In
the event of damage, have the tool repaired
before using it. Many accidents are due to badly
maintained tools.
f) Keep cutting tools sharp and clean. Properly
maintained tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the tool, accessories and blades etc.,
in accordance with these instructions, while
taking into account the work conditions and
the work to be done. The use of the tool for
operations other than those intended could
result in dangerous situations.
5 – Maintenance and service
a) Have the tool serviced by qualified repair
personnel using only identical replacement
parts. This will ensure that the safety of the tool
is maintained.
SAFETY WARNINGS COMMON FOR GRINDING,
SANDING, WIRE BRUSHING, POLISHING OR
ABRASIVE CUTTING-OFF OPERATIONS:
a) This power tool is intended to function as
a grinder, sander, wire brush, polisher or cut-
off tool. Read all safety warnings, instructions,
illustrations and specifications provided with
this power tool. Failure to follow all instructions
listed below may result in electric shock, fire and/
or serious injury.
b) Operations other than recommend are
not to be performed with this power tool.
Operations for which the power tool was not
designed may create a hazard and cause personal
injury.
c) Do not use accessories which are not
specifically designed and recommended
by the tool manufacturer. Just because the
accessory can be attached to your power tool, it
does not assure safe operation.
d) The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool. Accessories running faster than
their rated speed can break and fly apart.
e) The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool. Incorrectly sized
accessories cannot be adequately guarded or
controlled.
f) The arbour size of wheels, flanges, backing
pads or any other accessory must properly fit
the spindle of the power tool. Accessories with
arbour holes that do not match the mounting
hardware of the power tool will run out of
balance, vibrate excessively and may cause loss
of control.
g) Do not use a damaged accessory. Before
each use inspect the accessory such as
abrasive wheels for chips and cracks, backing
pad for cracks, tear or excess wear, wire
17