Matrix DWS 600-1 Traduction De La Notice Originale page 19

a) Maintain a firm grip on the power tool and
position your body and arm to allow you to
resist kickback forces. Always use auxiliary
handle, if provided, for maximum control
over kickback or torque reaction during start-
up. The operator can control torque reactions or
kickback forces, if proper precautions are taken.
b) Never place your hand near the rotating
accessory. Accessory may kickback over your
hand.
c) Do not position your body in the area
where power tool will move if kickback
occurs. Kickback will propel the tool in direction
opposite to the wheel's movement at the point of
snagging.
d) Use special care when working corners,
sharp edges etc. Avoid bouncing and snagging
the accessory. Corners, sharp edges or bouncing
have a tendency to snag the rotating accessory
and cause loss of control or kickback.
e) Do not attach a saw chain woodcarving
blade or toothed saw blade. Such blades create
frequent kickback and loss of control.
SAFETY WARNINGS SPECIFIC FOR
SANDING OPERATIONS:
a) Do not use excessively oversized
sanding disc paper. Follow manufacturers
recommendations, when selecting sanding
paper. Larger sanding paper extending beyond
the sanding pad presents a laceration hazard
and may cause snagging, tearing of the disc or
kickback.
SAFETY WARNINGS COMMON FOR
DRYWALL SANDER :
Attention! You must abide by the following basic
safety measures against electrical shocks, injuries
and the danger of fire when using electric tools.
Read and abide by these instructions before you
start to use any tools. These instructions must be
kept in a safe place.
1. The equipment must never be used in
surroundings where an explosive atmosphere
exists.
2. Do not let the cable touch any parts of your
body.
3. .Only use the extension cable approved for use
in the working area.
4. .Do not force the machine for unsuitable work,
for example, rough grinding, brushing, etc.
Otherwise, dangers and harms will be caused.
5. Only use identical replacement parts when
servicing. Otherwise, risk-free operation can't be
guaranteed.
6. .The accessories' allowed speed must be
at least the same as the maximum speed of
the machine. Or else, they may be broken or
cracked when their running speed is go over the
machine's allowed speed.
7. .Do not use damaged accessories. Before use,
always check whether the accessories are nicked
or cracked. For example, to grinding pad, please
check the support plate is not cracked. Ensure
everybody to be out of the machine's rotation
area and run the machine at max. speed for one
minute, which can fully test the accessories.
8. .Do not put down the machine when it isn't
stopped completely. Otherwise, you will loss
control to the machine.
9. .Cleaning the exhaust port on your machine in
regular.
When working, control the machine firmly with
both hands to ensure safe operation.
10. .When sanding, do not use too big sandpaper.
19