AEG GS45AVB Notice D'utilisation page 68

68 www.aeg.com
Problem and alarm code
The appliance does not fill with water.
• The end indicator flashes 1 time in-
termittently.
• Acoustic signal sounds 1 time in-
termittently.
The appliance does not drain the wa-
ter.
• The end indicator flashes 2 times
intermittently.
• Acoustic signal sounds 2 times in-
termittently.
The anti-flood device is on.
• The end indicator flashes 3 times
intermittently.
• Acoustic signal sounds 3 times in-
termittently.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
11.1 The washing and drying results are not satisfactory
Problem
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry water
drops on glasses and dishes.
The dishes are wet.
Refer to "Hints and tips" for
other possible causes.
Possible solution
• Make sure that the water tap is open.
• Make sure that the pressure of the water sup-
ply is not too low. For this information, contact
your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not
clogged.
• Make sure that the inlet hose has no kinks or
bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or
bends.
• Close the water tap and contact an Authorised
Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
Possible solution
• The release quantity of rinse aid is too much. Adjust
the rinse aid selector to a lower position.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient. Ad-
just the rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
• The programme does not have a drying phase or has
a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.