Whirlpool WRT371SZBB00 Instructions D'utilisation page 8

9. Remove the door stop from the bottom of the freezer door.
A. Door stop screw
B. Door stop
10. Move the door stop to the opposite side making sure that the
hole in the door stop plate is aligned perfectly with the hole for
the center hinge pin.
11. Using the screw removed in Step 9, fasten the door stop to
the bottom of the freezer door.
A. Door stop screw
12. Tighten all screws. Set aside the freezer door until the hinges
and refrigerator door are in place.
Reverse Refrigerator Door
1. Remove the door stop from the bottom of the refrigerator
door.
A. Door stop screw
B. Door stop
2. Replace the door stop on the opposite side of the refrigerator
door, making sure that the hole in the door stop plate is
aligned perfectly with the hole for the bottom hinge pin.
3. Fasten the door stop to the door.
4. Remove the screws from the top of the refrigerator door
handle.
5. Remove the setscrew from the lower part of the handle.
8
A B
A
A B
6. Pull the handle away from the door to release it from the
shoulder screw. Keep all parts together.
C
A. Flat-head handle screws
B. Refrigerator door handle
7. Remove the decal covering the hole on the opposite side of
the door, where the refrigerator door handle will be installed,
and discard the decal.
8. Remove the shoulder screw from the left-hand side of the
door and fasten it into the hole that was behind the decal.
9. Place the handle on the shoulder screw and push the handle
toward the door until the mounting base is flush against the
door. Tighten the setscrew.
10. Fasten the top of the refrigerator handle to the top of the
refrigerator door.
A. Flat-head handle screws
A
B
¹⁄₄
C. " Setscrew
A