Beurer MG 254 Mode D'emploi page 13

• U se the flexible fastening straps and Velcro strips to secure the Shiatsu seat cover.
• Connect the device to the mains by plugging the plug into the socket.
7. Operation
Gently press your back against the massage device to start with. Then make sure that you are in a comfort-
able position before gradually shifting your weight onto the massage device.The massage must be pleasant
and relaxing at all times. Stop the massage or change your position or the contact pressure if you find it is
painful or unpleasant.
• D o not force or jam any part of your body, in particular your fingers, between the rotating massage elements
or their holders in the unit.
• S it comfortably and upright on the seat cover. Ensure you sit centered and such that the massage heads
can move to the left and right of your spinal column.
• Switch on the massager with the
The LEDs signal the massage functions which are currently selected.
You can specify the settings as follows:
1. Demo run
Press the demo button to begin a quick 5-minute run-through of the functions contained in the device.
The manual controller indicates which function is being displayed by flashing the respective LED. The
device switches off automatically once the demo run has finished.
2. Shiatsu neck massage
Press the neck
or neck (clockwise rotation) button to change the direction of the massage.
3. Shiatsu back massage
Press the shiatsu button. Then press the full back, upper back or lower back button to select
the desired massage area.
Massage intensity
When using the Shiatsu Massage, two different massage speeds are available, which can be selected
using the speed button.
4. heating function
Press the heat button to switch on the heating function of the massage heads. The blue lights in the mas-
sage heads change colour to red.
• Do not use the massage device for longer than 15 minutes and then allow it to cool. Using the device
for longer can over-stimulate the muscles and cause tension instead of relaxation. The massage can be
finished at any time by pressing the button. Please note that on switching off, the massage heads first
return to the starting position at the lumbar region. This is indicated by the LED flashing. Once this position
is reached, the device switches off.
• If the device is stopped be pressing a massage area button twice, it also returns to the starting position
after 15 minutes and then switches off.
• Do not disconnect the device from the mains supply during operation. Always switch it off first and wait
until it has returned to the initial position.
note
• T he device has an automatic shut-off mechanism set to a maximum operating period of 15 minutes.
8. Care and storage
CLeanInG
WarnInG
• O nly clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
button.
button to start the neck massage. Press the neck
13
(anti-clockwise rotation)