hergom Compact SERE 100 2C Instructions D'installation, De Service Et D'entretien page 21

FIG. 14 - Safety distances
REPLACING THE POWER SUPPLY CABLE
If the power supply cable has been damaged, it
should be replaced by the manufacturer, via its
Technical Service, or by qualified personnel, in
order to avoid risks.
When installing the compact SERE 2C fireplace,
follow the installation advice below for your own
safety:
1. The base where you are going to place your
SERE 2C must be flat and provide a perfect seat
for your fireplace. The base must be built using
heat resistant materials.
2. The gap in which your SERE 2C fireplace will be
installed must be completely free from debris
and waste materials that may ignite when the
fireplace is working.
3. The inside of the gap where the SERE 2C
fireplace is to be installed will be appropriately
insulated or built of materials that resist high
temperatures.
4. If insulation must be installed inside the gap,
do not cover the ventilation grille.
5. Never wrap the insert fireplace in insulation
material as this will damage it.
INDUSTRIAS HERGÓM, S.A., rejects any liability
derived from a faulty installation or incorrect use
and reserves the right to alter its products without
prior warning.
Any liability due to manufacturing defects will
be subject to the criteria and verification of the
company's experts and will be limited to the
repair or replacement of its products, excluding
any construction work or damage the said repairs
may cause.