hergom Compact SERE 100 2C Instructions D'installation, De Service Et D'entretien page 18

4 - DESMONTAJE DEL VENTILADOR
ATTENTION! Before working on electrical parts
be sure the appliance has been disconnected
from the mains.
In order to replace the fans, observe the following
instructions:
1. Remove the grill and the bottom section. Pay
attention to vermiculite parts; they can break.
(Fig. 9)
2. Loosen the screws on the side covers, which
give access to the fan assembly, located under
the base. (Fig. 10)
3. Caution! The thermostat is located under one
of the side covers. Unscrew the thermostat.
(Fig. 11)
FIG. 9
FIG. 10
4. Disconnect the terminals.
5. Remove the fans by unscrewing the nuts,
disengage the assembly from the hinges and
remove it by turning up. (Fig. 12)
6. Loosen the screws that fasten the fans on to
the support plate and if necessary release the
connection plate to help you remove the fan.
(Fig. 13)
7. Replace the damaged fan and install the fan
assembly by performing the above steps in
reverse order.
FIG. 11
FIG. 12
FIG. 13