Table des Matières
Publicité
Messages d'erreur SCPI
not able to change output load with limits enabled
not able to list arb, list turned off
not able to list DC, list turned off
not able to list noise, list turned off
not able to list PRBS, list turned off
not able to list this function
not able to modulate arb, modulation turned off
not able to modulate DC, modulation turned off
not able to modulate noise, modulation turned off
not able to modulate PRBS, modulation turned off
not able to modulate this function
not able to sweep arb, sweep turned off
not able to sweep DC, sweep turned off
not able to sweep noise, sweep turned off
not able to sweep PRBS, sweep turned off
not able to sweep this function
offset changed due to amplitude
offset changed on exit from DC function
PM turned off by selection of other mode or modulation
prbs edge time increased due to amplitude (série 33600 uniquement)
pulse duty cycle and edge times increased due to amplitude (série 33600 uniquement)
pulse duty cycle decreased due to period
pulse duty cycle increased due to amplitude (série 33600 uniquement)
pulse duty cycle increased due to period
pulse edge times increased due to amplitude (série 33600 uniquement)
pulse width and edge times increased due to amplitude (série 33600 uniquement)
pulse width decreased due to period
pulse width increased due to amplitude (série 33600 uniquement)
pulse width increased due to large period
PWM deviation decreased due to pulse parameters
PWM only available in pulse function
PWM turned off by selection of other mode or modulation
Range hold turned off by selection of new function (série 33600 uniquement)
466
Guide d'utilisation et de maintenance Agilent Série Trueform
Publicité
Table des Matières
