Technical Specifications - Genie 270 CD Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

down for an appropriate length of time. The maximum continuous operation time of 2 minutes

can only be reached with a sufficiently cool device. Cooling the device down sufficiently to

operate it again for 2 minutes takes around 60 minutes.

Removal of leftover paper:

Set the switch to "OFF" and unplug the power socket. Remove the shredding attachment and

then you will able to take out any scraps of paper that have become caught in the cutting unit.

The blades are very sharp so you should proceed with extra caution! Place the shredder

attachment back on top, plug in the power socket and turn the device on again. You will then

be able to start using the device again.

Turning off:

Set the switch to "OFF" in order to turn the device off entirely.

Separate cutting unit for CDs and credit cards:

This shredder is fitted with a separate cutting unit for CDs/DVDs and credit cards. Set the

switch to FWD and insert the CDs / DVDs into the slot behind the flap where they will be cut

into 3 pieces. Keep your face at a suitable distance from the device when inserting CDs/DVDs

since these materials are at risk of splitting. The shredded material is collected in a separate

container which will help you dispose of the waste in an environmentally-friendly manner.

Insert credit card:

1. Open the security door on the CD / credit card input opening.

2. Insert the card into the top center of the CD / credit card input opening. You can only cut up

one credit card at the time. Do this always ahead with the broad side into the CD / credit

card input opening. Otherwise, the magnetic strip is not destroyed.

Insert CDs:

1. Insert the CD centrally from above into the CD / credit card input opening. You can only cut

just one CD.

2. Do not insert your finger into the central hole of the disc when you insert it into the

device, there is danger of injury!