BORETTI BTG-80 Notice D'emploi page 85

Turning off a burneR
Briefly press the "+" and "-" buttons for the desired burner simultaneously. The power level indi-
cator shows letter "H" indicating that the burner is still hot. This indication is cleared after a few
minutes.
Turning off all burners
To turn off all burners simultaneously, briefly press the ON/OFF button: the appliance will enter
standby mode.
Setting the clock
After a power failure, the hob clock must be
reset.
To set the clock, simultaneously press and
hold the buttons shown in the figure for at
least 3 seconds. The flashing digits on the left
of the dot indicate the hour and the digits on
the right indicate the minutes. Increase or de-
crease the hour using the "+" and "-" buttons.
Hold down the "+" or "-" button to increase or decrease the hours digits rapidly.
To set the minutes, press the button with the clock symbol again. The digits on the right of the dot
will start flashing; set the minutes as described above. Press the button with the clock symbol
again to save the set time.
Burner reset
The burners may lock out due to external faults (for example, in the event of either a power or
gas supply failure).
The display of each locked out burner will show the letter "b". To reset the burners, simultaneously
hold down the "-" and "key" buttons as shown in the figure for at least 2 seconds.
Once the burners have been reset, they will be set to level 0, ready to be turned on again.
N.B.: If you repeat the reset procedure 5 consecutive times within 15 minutes, the message
FLT06 will be displayed and no other reset requests will be accepted for the following 15 minu-
tes.
NL
FR
D
EN
85