Using The Appliance - 4-Burner Version - BORETTI BTG-80 Notice D'emploi

Using the appliance - 4-burner version

The symbols printed above each burner control show the correspondence between the control
and the burner.
Standby mode
After connecting the appliance to the power supply, it will perform a brief self-diagnosis routine
and touch panel calibration (all displays and LEDs remain illuminated for a few seconds). When
this procedure is completed the display will be blank.
Switching on the hob
To switch on the hob, hold the ON/OFF button for at least 2 se-
conds.
The appliance will switch on and the fi ve burner displays will show
power level 0, meaning that the burners are off.
Lighting a burner
To light a burner, hold down the "+" and "-"
buttons on the control panel simultaneously
for at least 1 second. After a few seconds,
the selected burner will light and power
setting 5 will be selected automatically. The
associated indicator light will remain on as
long as the burner is lit.
All burners for which the timer has not been
set will turn off automatically after 4 hours of continuous operation.
Adjusting burner fl ame levels
After lighting the burner, press "+" to turn up the power level and "-" to turn it down. For continu-
ous variation of the power level hold down the "+" or "-" button and release it at the desired level.
Power levels can be adjusted from 1 to 9.
Burner response differs during upward and downward power adjustment:
--when the level is increased from 1 to 9, after the adjustment the burner fi rst assumes power
level 9 and then assumes the set level;
--when the level is decreased from 9 to 1, the adjustment is progressive.
84