Clutch Adjustment - Lega DV2 Guide D'instructions

5.1 CLUTCH ADJUSTMENT

Costruzioni Apistiche – via Maestri del Lavoro 23 – 48018 Faenza
www.legaitaly.com - Tel 054626834 – Fax 054628279 – P.iva 00043230390
Adjusting the clutch is an extremely easy
operation enabling to calibrate in an ideal way,
according to different operator requirements, the
pulling force of the frame conveyor chain.
Too 'tight' a clutch adjustment may cause
problems and could even break some frames
when they are fed on between blades.
Conversely, too 'loose' a clutch adjustment would
prevent uncapping as the frame would stop every
time that even a minor obstacle is encountered.
By using a size 4 Allen wrench, undo the 4
screws securing the round teflon guard on the
rear of the control panel.
By using two no. 22 spanners, unlock the lock
nut and tighten or loosen the nut until the right
adjustment is obtained, then re-tighten the lock
nut to fix the whole assembly. Replace the
guard before restarting the machine.
18 / 40