Indel B TB 2001 Instructions D'utilisation page 8

ENGLISH
INSTALLATION
WARNING
do not install the refrigerator near heat sources. This device can work at a MAXIMUM INCLINATION
OF 30°.
SHOULD THE CAB BE TIPPED OVER, TURN OFF THE REFRIGERATOR.
THE REFRIGERATOR MUST BE INSTALLED EXCLUSIVELY INDOORS.
FASTENING THE REFRIGERATOR
To fasten the device, use the plates and ball pins provided with each device.
This system allows you to anchor the refrigerator firmly to the vehicle and if necessary to remove it by a
simple operation.
Proceed as follows:
- fasten the pins to brackets using the nuts
- press the pins in place connected to the brackets in their seats fitted with springs on the bottom of the
unit;
- place the unit in its compartment. Make sure the ventilation grids are not covered. Lock the brackets in
place using the screws. (Figure 1)
WIRING SYSTEM
Compressor station
Functions and features.
This is an electronic device which has the function of piloting the motor of the compressor and carrying
out all the controls and electrical protection of the system.
Its main features are as follows:
a) Protection of the battery through automatic turning off of the compressor when the feeding voltage
reaches the minimum threshold.
The compressor will start up again automatically when the voltage goes back to normal values.
b) Amperometric protection in case the compressor should fail to start up .
This generally happens when the pressures do not have time enough to balance themselves again.
Should this kind of protection come into action, the compressor will carry out a 1 minute pause and will
then start up again automatically.
8
TABLE OF THE VOLTAGES AT WHICH
THE BATTERY SAVER COMES INTO ACTION
BATTERY SAVER VOLTAGE
VOLTAGE
12V Volt 10.1
24V Volt 22.,3
STOP START UP AGAIN
Volt 11.4
Volt 23.7
TB 2001
TB 2001_07-09-2017