Hach SC4200c Profibus Instructions D'utilisation page 3

Table of Contents
1 Specifications on page 3
2 General information on page 3
3 Installation on page 6
Section 1 Specifications
Specifications are subject to change without notice.
Specification
Profibus protocol
DP service
DP/DPV1 services
Profibus baud rates
Indicators
Interface type
Configurable parameters Data swapping, word wise for floating points values
Operating temperature
Storage temperature
Operating voltage
Power consumption
Wiring
Certification
Section 2 General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
2.1 Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
1
Do not use wire gauge other than 0.08 to 1.5 mm
from mains power and relay circuits.
Details
Siemens ASIC SPC3
DPV0 slave
DPV1 class 1 and class 2 slave
I&M function
Address changing per Profibus master
9.6k, 19.2k, 45.45k, 93.75k, 187.5k, 500k, 1.5M, 3M, 6M, 12M
Automatic baud rate detection
LED to display the data exchange mode
RS485
-20 to 60 °C (-4 to 140 °F); 95% relative humidity, non-condensing
-20 to 70 °C (-4 to 158 °F); 95% relative humidity, non-condensing
8 V to 16 V
2 W maximum
Wire gauge: 0.08 to 1.5 mm
1
higher
Listed for use with the SC4200c controller in Class 1, Division 2, Group A, B, C and D,
Zone 2, Group IIC hazardous locations to FM and CSA safety standards by ETL
N O T I C E
4 Configuration on page 17
5 Troubleshooting on page 17
2
(28 to 16 AWG) with an insulation rating of 300 VAC or
2
(28 to 16 AWG), unless wires can be isolated
English 3