Event Log - Hach SC4200c Profibus Instructions D'utilisation

Bit Message
13 Measurement 3 Quality Bad Precision of measurement is out of the specified limits.
14 Measurement 3 Low Limit
15 Measurement 3 High Limit

5.2 Event Log

Refer to Table 4 for diagnostic device information.
Event
ADDRESS
DATA ORDER
SIMULATION
SENSOR POWER
SET DATE/TIME
NEW CONFIG
AUTO CONFIGURE
CODE VERSION
Table 3 Status indicator messages (continued)
Indication
Measurement is below the specified range.
Measurement is above the specified range.
Table 4 Event log
Description
Adjusted Profibus address
Indicates the data order of 2 word variables in the cyclic and acyclic Profibus telegram
Indicates if the simulated data is set into the cyclic Profibus telegram.
Timestamp of the Profibus card power up
Setup timestamp of the internal timer of the Profibus card
Timestamp of a new configuration
Timestamp of a new menu setting
Timestamp of a new software download (Software version)
English 19