About Ipod; Maintenance - Sony CDX-G3000UP Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

About iPod

 You can connect to the following iPod
models. Update your iPod devices to the
latest software before use.
Made for
 iPod touch (5th generation)
 iPod touch (4th generation)
 iPod touch (3rd generation)
 iPod touch (2nd generation)
 iPod classic
 iPod nano (7th generation)
 iPod nano (6th generation)
 iPod nano (5th generation)
 iPod nano (4th generation)
 iPod nano (3rd generation)
 iPod nano (2nd generation)
 iPod nano (1st generation)*
 iPhone 5
 iPhone 4S
 iPhone 4
 iPhone 3GS
 iPhone 3G
* Passenger control is not available for iPod nano
(1st generation).
 "Made for iPod" and "Made for iPhone"
mean that an electronic accessory has
been designed to connect specifically to
iPod or iPhone respectively and has been
certified by the developer to meet Apple
performance standards. Apple is not
responsible for the operation of this device
or its compliance with safety and
regulatory standards. Please note that the
use of this accessory with iPod or iPhone
may affect wireless performance.
If you have any questions or problems
concerning your unit that are not covered in
this manual, consult your nearest Sony
dealer.
14
GB

Maintenance

Replacing the lithium battery of the
remote commander
When the battery becomes weak, the range
of the remote commander becomes shorter.
Replace the battery with a new CR2025
lithium battery. Use of any other battery may
present a risk of fire or explosion.
Notes on the lithium battery
 Keep the lithium battery out of the reach of
children. Should the battery be swallowed,
immediately consult a doctor.
 Wipe the battery with a dry cloth to assure a good
contact.
 Be sure to observe the correct polarity when
installing the battery.
 Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose
of in fire.
Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front
panel are not clean. In order to prevent this,
detach the front panel (page 5) and clean the
connectors with a cotton swab. Do not apply
too much force. Otherwise, the connectors
may be damaged.
+ side up

Publicité

Chapitres

Table des Matières
loading

Table des Matières