Christopeit Sport CX 7 Notice De Montage Et D'utilisation page 22

Step 6:
Attach the grip (21) at support (8).
1. Put the rear computer cover (4) onto the ends of grip (21).
2. Guide the grip (21) through the appropriate holder of support (8) and
adjust the holder so that the holes and threats align. Put on each screw
M8x25 (26) a spring washer for M8 (27) and a washer 8//16 (28) and
tighten the grip (21) at the support (8) firmly.
Step 7:
Attach the computer (1) at support (8).
1. Put the plug of connection cable (2) into the plug from computer (1)
backside.
2. Insert the plug of pulse cables (30) to the jacks of the computer (1) and
attach the computer (1) to top monitor bracket of support (8) with screws
M5x16 (3). Use screws from backside of computer. (Attention: Ensure
that the cable loom are not crunched or pinched during installation.)
3. Mount the front and rear computer cover (4+6) with each other and to
the support (8) and secure with screws M5x12 (5) and screws 4x20 (7).
Step 8:
Attach the power with adaptor (85).
1. Please insert the cable plug of adaptor (85) into the DC cable plug (58)
at end of chain guard (97).
2. Please insert the adaptor (85) into a well-installed socket with wall power
(230V~50Hz).
Step 9:
Checks
1. Check the correct installation and function of all screwed and plug
connections.
Installation is thereby complete.
2. When everything is in order, familiarise yourself with the machine at a
low resistance setting and make your individual adjustments.
Note:
Please keep the tool set and the instructions in a safe place as these may
be required for repairs or spare parts orders becoming necessary later.
22