Christopeit Sport CX 7 Notice De Montage Et D'utilisation page 20

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check that all are there on the basis of the assembling steps. Please
note that a number of parts have been connected directly to the main
frame and preassembled. In addition, there are several other individual
parts that have been attached to separate units. This will make it easier
and quicker for you to assemble the equipment. Assembly time ap-
prox. 60min.
Step 1:
Attach the stabilizer (45+55) at main frame (40).
1. Attach the front foot (45) with preassembled transportation roller (44+46)
to the main frame (40). Do this with the two screws M8x55 (41), washers
8//16 (28) and self-locking nuts M8 (43).
2. Attach the rear foot (55) with preassembled height adjustable screw
(57) to the main frame (40). Do this with the two screws (41), washers
(28) and self-locking nuts (43). After assembly has been completed, you
can compensate for minor irregularities in the floor by turning the foot
screw (57). The equipment should be set up that the equipment does
not move of its own accord during a training session.
Step 2:
Connection of cables (2+39) and assembly of support (8) at
the main frame (40).
1. Place screws M8x16 (32), washers 8//16 (28), curved washers 8//19 (33)
and spring washers for M8 (27) accessibly beside the front part of the
main frame (40).
2. Place the lower end of the support (8) against the main frame (40) and
plug the ends of the two computer cable harnesses (2+39) projecting
from (8+40) together.
(Note: The computer cable harness (2) projecting from the support (8)
must not slide into the tube, as it is required for later steps of installation.)
When joining the tubes, ensure that the cable connection will not
trapped.
3. Put one spring washer (27) and one washer (28) or curved washer (33)
on each screw (32). Push the screws (32) through the holes in the support
(8), screw into the threaded holes of the main frame (40) and tighten
firmly.
Step 3:
Installation of the footrest holder (100+103) at pedal crank (91).
1. Put the left footrest holder (103) at the pedal crank (91) on left hand
side and tighten the footrest holder (103) with washers 8//22 (14),
spring washer for M8 (27) and screw M8x20 (99) firmly. Put the screw
cover (98) onto the footrest holder (103).
2. Push the connection tube cover (31) onto left connection tube (34) into
intended position and tighten with screws M5x12 (5).
3. Install the right footrest holder (100) incl. all additionally required parts
on the right hand side of the machine as described in 1. – 2.
20