Settings For Digital Audio Output; Audio Setup Page; Audio Drc - Sony MV-650STR Mode D'emploi

Settings for digital audio
output

- Audio Setup page

- - A u d i o S e t u p
D o w n m i x
S P D I F O u t p u t
A u d i o D R C
S e l e c t : < , S e t : E n t e r Q u i t : S E T U P
♦
Downmix
You can select the downmix mode from
"Surround" or "Normal". The downmix
function is used to create stereo (2-channel)
signals from more than 5 separated digital
signals of a source. This setting affects the
outputs of AUDIO OUTPUT.
Surround Select this when the connected
audio equipment supports Dolby
Surround (Pro Logic).
Normal Select this when the connected
audio equipment does not support
Dolby Surround (Pro Logic).
♦
SPDIF Output
You can set the mode of the audio signals
output from the OPTICAL OUTPUT
connector.
Off No signal is output from OPTICAL
OUTPUT connector.
RAW Select this when you connect an
audio component with a built in
Dolby Digital decoder or DTS
decoder.
PCM 48K Select this when you do not
connect an audio component with
a built in Dolby Digital decoder or
DTS decoder.
Notes
• When "Off" is selected, no signal is output from
the OPTICAL OUTPUT connector.
• When you connect the player and a digital
recording device such as an MD player through
an optical cable to record the CD contents with
that device, the contents will be recorded as one
continuous track.
28
P a g e - -
♦

Audio DRC

Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "Audio DRC". You can set the
DRC (Dynamic Range Control) level from 8
steps. This setting affects the outputs of
AUDIO OUTPUT.
FULL: Makes the low sounds clear even if you
turn the volume down.
OFF