Rear Panel - Omnitronic DMS-1150 Mode D'emploi

29. FILTER/PHASE-BUTTON
With the Filter/Phase-button, you can activate the Filter-function or Phase-function. Please refer to the
explanations under 6.11 Effects.
30. HOLD-BUTTON
With the Hold-button, you can hold the settings of the effect-parameters and sample-parameters. Please
refer to the explanations under 6.11 Effects.
31. ECHO/FLANGER-BUTTON
With the Echo/Flanger-button, you can activate the Echo-effect or Flanger-effect. Please refer to the
explanations under 6.11 Effects.
32. TRANS/PAN-BUTTON
With the Trans/Pan-button, you can activate the Trans-effect or Pan-effect. Please refer to the explanations
under 6.11 Effects.
33. REVERSE-BUTTON
With the Reverse-button, you can activate the Reverse-function. Please refer to the explanations under 6.11
Effects.

4.3 Rear panel

34. AUDIO OUT-SOCKETS
The music-signal of these sockets is analogue. Connect the output to the respective input of your mixer.
35. DIGITAL OUT-SOCKET
The music-signal of this socket is digital. Connect the output to the respective input of a digital amplifier for
example.
36. RELAY-SOCKET
To connect a mixer or CD-player.
37. POWER SWITCH
Press this button to start operation.
38. AC CONNECTION
Plug in the power supply cable here.
39. VOLTAGE SELECTOR
Make sure that the indication corresponds to the available voltage.
26/64 10602426_V_1_0.DOC