Putting Out Of Operation - Abicor Binzel ABIMIG WT Mode D'emploi

7 Putting out of operation

7 Putting out of operation
EN - 12
NOTICE
• When putting the system out of operation, ensure that the procedures for
switching off each of the welding system components are observed.
• As liquid-cooled cable assemblies start to leak when they overheat, the
coolant recirculator should continue running for approx. 5 min. after
welding.
1 Wait until the shielding gas post-flow time has passed.
2 Close the shut-off-valve for the gas supply.
3 Switch off the power source.
4 Switch off the coolant recirculator.
®
ABIMIG WT