Bosch PSR Select Notice Originale page 33

OBJ_BUCH-1564-004.book Page 33 Monday, January 18, 2016 11:10 AM
English | 33
 Do not continue to press the On/Off switch after the machine has
been automatically switched off. The battery can be damaged.
The battery is equipped with a NTC temperature control which allows charg-
ing only within a temperature range of between 0 °C and 45 °C. A long bat-
tery service life is achieved in this manner.
When the battery charge-control indicator 5 lights up red while the On/Off
switch 10 is depressed half way, then the battery has less than 30% of its
capacity and should be charged.
The charging procedure begins as soon as the mains plug of the battery
charger is plugged into a socket outlet and the charge connector 14 is
plugged into the socket 9 on the bottom of the handle.
Due to the intelligent charging method, the charging condition of the battery
is automatically detected and the battery is charged with the optimum charg-
ing current, depending on battery temperature and voltage.
The battery charge-control indicator 5 indicates the charging progress. The
indicator flashes green during the charging procedure. When the battery
charge-control indicator 5 no longer lights up, the battery is completely
charged. When the battery charge-control indicator 5 lights up red, the bat-
tery temperature is too high.
During the charging procedure, the handle of the machine warms up. This is
normal.
Disconnect the battery charger from the mains supply when not using it for
longer periods.
The power tool cannot be used during the charge procedure; it is not defec-
tive when inoperative during the charging procedure.
Observe the notes for disposal.
Inserting Screwdriver Bits into the Bit Magazine
(see figure B–C)
Bosch Power Tools 1 609 92A 20W | (18.1.16)