Installing Built-In Models - Salvis Smartline AKP1 BI371828 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9.5

Installing built-in models

Corner posts
Holding rail
Drain tap
Cut-out in front panel
on the furniture for
the control panel
Apply Pactan adhesive
all around with
approx. ø 8-10 mm
Si-foam sealing profile
Rosette
Drain pipe
Screw
● Built-in models may not be installed in com­
bustible worktops and appliance housings.
● Built-in models can be installed in CNS or
stone worktops up to 40 mm thick.
● It must be ensured that live electrical parts can
no longer be touched after installation.
● Do not install appliances on top of heat
sources.
Installation
Control panels and appliance top are preassem­
bled. Do not pull off the connecting cables!
. Make the installation cut-outs and mounting
holes as per drawing (page 32 chapter 9.6)
into the worktop and front panel.
. Mount the corner posts.
. Degrease bonding spots on the top of the ap­
pliance and on the worktop.
. Affix Si-foam sealing profile along the cut-out
‒ Si-foam sealing profile 5x3 mm self-adhe­
sive, item no.: 604151.
● The sealing profile prevents the Pactan adhe­
sive from being pressed in too far and the ad­
hesive seal from becoming too wide.
. Apply Pactan adhesive along the Si-foam seal­
ing profile.
‒ Pactan adhesive set 7076 - 150 ml (TB 77)
with spatula, item no.: 888585
‒ Pactan cartridge 7076 - 310 ml, item
no.: 373060
. Guide the front panel from the top through the
cut-out in the worktop and then out through the
front panel cut-out.
. Insert the built-in module in the worktop cut-
out, align, press down and fasten with holding
rail.
. Remove excess Pactan from the visible side.
. Hook front panel on the top in the corner posts,
make contact below and screw tight.
Appliance with drain tap
. Slide rosette on drain pipe.
. To seal the drain tap's thread, apply Loctite
510 on the drain pipe.
. Screw the drain tap on the drain pipe.
. Fix the rosette and drain tap with screw on the
drain pipe.
en
31 / 64

Publicité

Table des Matières
loading

Table des Matières