Audio Settings - Pioneer MVH-X580DAB Mode D'emploi

Menu Item
TA
[DAB+RDS TA]
[RDS TA ONLY]
[TA OFF]
AF
[ON], [OFF]
NEWS
[ON], [OFF]
SEEK
[MAN], [PCH]
SAVE
UNSAVE
SEL DEVICE
iPod
S.RTRV
USB iPod
[1] (effective for low compression
rates),
[2] (effective for high
compression rates),
[OFF]
AUDIO BOOK
iPod
[FASTER], [NORMAL], [SLOWER]
16
En
Description
Receive current traffic information for DAB and
RDS (DAB has priority) if available.
Receive current traffic information for only RDS if
available.
Disables this function.
Allow the unit to retune to a different frequency
providing the same station. (Available only when
FM band is selected.)
Interrupt the currently selected source with
news programs. (Available only when FM band is
selected.)
Assign or buttons to seek the stations
one by one (manual tuning) or select a station
from the preset channels.
Store the information about the song currently
being played to your music list on Spotify.
Remove the song information stored in [SAVE].
Connect a Bluetooth device in the list.
AU
Enhance compressed audio and restore rich
sound.
Change the playback speed. (Not available when
[CONTROL iPod] is selected in the control mode.)
Menu Item
PAUSE
PLAY
STOP
*1 Only available in areas where [SOFTLINK] function is supported.
*2 Not available when [S.FOLLOW] function is turned off.

AUDIO settings

Menu Item
EQ SETTING
[SUPER BASS], [POWERFUL],
[NATURAL], [VOCAL], [CUSTOM1],
[CUSTOM2], [FLAT]
Select an equalizer band and
level for further customizing.
Equalizer band: [50HZ] to
[12.5kHZ]
Equalizer level: [–6] to [+6]
FADER*1 (Only for standard mode)
BALANCE
SUBWOOFER
[ON], [OFF]
SUBWOOFER*2
[NOR], [REV]
Description
Pause or resume playback.
Start playback.
Stop playback.
Description
Select or customize the equalizer curve.
• When you select a setting other than
[CUSTOM1] and [CUSTOM2], you can also
customize the equalizer curve by pressing and
holding the M.C. dial, then store the
customized equalizer curve in [CUSTOM1].
Adjust the front and rear speaker balance.
Adjust the left and right speaker balance.
Set to [ON] when using a subwoofer speaker.
Select the subwoofer phase.