Audio Settings - Pioneer DEH-1700UB Mode D'emploi

Menu Item
LOCAL
FM: [OFF], [LV1], [LV2], [LV3], [LV4]
MW/LW: [OFF], [LV1], [LV2]
TA
[ON], [OFF]
AF
[ON], [OFF]
NEWS
[ON], [OFF]
SEEK
[MAN], [PCH]
S.RTRV
USB
[1] (effective for low compression
rates), [2] (effective for high
compression rates), [OFF]

AUDIO settings

Menu Item
FADER*1
BALANCE
8
En
Description
Restrict the tuning station according to the
signal strength.
Receive current traffic information if available.
(Available only when FM band is selected.)
Allow the unit to retune to a different frequency
providing the same station. (Available only when
FM band is selected.)
Interrupt the currently selected source with
news programs. (Available only when FM band is
selected.)
Assign or buttons to seek the stations
one by one (manual tuning) or select a station
from the preset channels.
Enhance compressed audio and restore rich
sound. (Not available when the FLAC file is
played back.)
Description
Adjust the front and rear speaker balance.
Adjust the left and right speaker balance.
Menu Item
EQ SETTING
[SUPER BASS], [POWERFUL],
[NATURAL], [VOCAL], [CUSTOM1],
[CUSTOM2], [FLAT]
Select an equalizer band and
level for further customizing.
Equalizer band: [80HZ], [250HZ],
[800HZ], [2.5KHZ], [8KHZ]
Equalizer level: [+6] to [–6]
LOUDNESS
[OFF], [LOW], [MID], [HI]
SUB.W*2
[NOR], [REV], [OFF]
SUB.W CTRL*2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level: [–12], [–24]
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*3 Not available when [OFF] is selected in [SUB.W].
Description
Select or customize the equalizer curve.
[CUSTOM1] can be set separately for each source.
However, each of the below combinations are set
to the same setting automatically.
[CUSTOM2] is a shared setting used for all
sources.
You can also switch the equalizer by pressing
repeatedly.
Compensate for clear sound at low volume.
Select the subwoofer phase.
Only frequencies lower than those in the
selected range are output from the subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
Adjust the volume level for each source except
FM.