The working grade of the winch stacker: 1BM.
Warning: pay attention to the winch lever kick back when in lifting will cause a risk.
1.
The machine shall not be used on gradients due to possible excessive efforts
and loss of control.
2.
The machine shall not be used in places insufficiently illuminated.
3.
The machine shall not be used to lift or to transport persons.
4.
The machine shall not be used as a vehicle jack.
5.
The extremity of fork arms shall not be used as a lever to lift a load.
6.
The machine shall not be used in applications where a risk of exceeding the
rated capacity exists.
7.
The machine shall not be used in applications where a risk of unintentional
movement exists.
8.
The machine shall not be used for handing free swinging loads.
9.
The machine shall not be travel with its fork arms in the upper position except
for loading and unloading operations.
10. The machine shall not be have direct contact with foodstuffs.
11. The machine shall not be used in a potentially explosive atmosphere.
12. Using the machine for any purpose other than lifting material is unsafe.
5.1 Raising and Lowering Load
1.
Centre the load on the forks.
2.
Raise the load by firmly grasping the winch handle and rotating it clockwise. Do
not allow the cable to wind unevenly onto the winch drum.
3.
Lower the load by firmly grasping the winch handle and rotating it
counterclockwise. After lowering to the desired position, loosen the winch
handle.
5.2 Moving Machine with a Load
It is best to move the machine without load. Moving a raised load should be
restricted to positioning for loading and unloading. If it is necessary to move the
machine with a raised load, understand and obey the following safety rules:
1.
Area is level and clear of obstructions.
2.
Load is centred on the forks.
3.
Avoid sudden starts and stops.
4.
Travel with load in the lowest possible position.
5.
Keep personnel away from machine and load.
6.
Do not tilt the machine back with a raised load.
7.
The machine shall be moved slowly and smoothly.
8.
While moving no part of the fork arms or of the load shall come into contact
with an obstacle.
9.
During moving neither the fork arms nor the load shall rest upon an obstacle.
5. Operating Instructions
7