Olsberg Confort Notice D'utilisation page 9

• The heater risks overheating if it is
covered.
• It is therefore strictly forbidden to
cover or block the air intakes or
outlets at the risk of causing an
accident or damaging the heater.
WARNING:
DO NOT COVER!
WARNING: Very hot surface!
• Do not insert anything into the
heater.
• The heater may only be connected
by a qualified person after the power
has been switched off.
• All service operations must be
performed by
authorised person after the power
has been switched off.
• The installation must include an
omnipolar circuit breaker with a
contact opening gap of at least
3mm.
• The heater must not be installed
underneath a power socket.
• Comply
with
installation distances from floors,
walls, furniture, etc.
• The power supply must be protected
by a residual current device of at
least 30mA,
installed in a room with a bath or
shower.
• When installing the heater in bath-
rooms, comply with local regu-
lations.
• If
the power
damaged, it must be replaced by the
manufacturer, its after-sales service
or a person with similar quali-
fications in order to prevent any
potential hazards.
a qualified and
the minimum
especially when
supply cable
• Avoid installing the heater in a
draught which may otherwise affect
its thermostat control.
• This
direct
designed for ambient heating of
residential type rooms, or similar, in
new or existing, single and multi-unit
dwellings.
is
electric heater is
9