Argos Technologies RotoFlex Plus Tube Rotator R2200 Manuel De L'utilisateur page 5

8. Oscillating Mode:
a. Push the "mode" key to select the oscillating mode.
The digital display will be activated and register 00.
b. The rotisserie will oscillate back and forth 9 times in a cycle while rotating at a
rate of 3 rpm. Once the oscillation cycle is complete, the rotisserie will be begin
to rotate at a speed of 40 rpm until the next oscillation cycle occurs, every 2
seconds or one complete rotisserie revolution.
c. The up and down arrow keys will not function in the oscillation mode.
d. By depressing the "mode" key once again, the instrument returns to the rotational
mode, displaying the last speed selected.
9. When finished, turn the power switch off before removing tubes.
Caution: Do not touch plug with wet hands or use the device near a water source.
Changing Rotisseries
1. Firmly grasp the RotoFlex Plus rotator with your left hand while holding the
rotisserie axle with your right hand. Gently pull the rotator body with your left hand
outward until the axle is free of the unit.
2. Remove the opposite side of the axle body by pulling it gently from the RotoFlex
Plus housing.
3. Select the rotisserie you wish to utilize and mount them on the RotoFlex Plus axle.
4. Insert the axle back into the RotoFlex Plus housing and turn until the axle clicks
into place.
5. Gently pull the rotator body (as in step 1) and reinsert the axle.
6. Turn the unit on to allow the rotisserie axle to align with the RotoFlex Plus motor.
Argos Technologies RotoFlex Plus Tube Rotator — Operator's Manual
™
4