Honda WX10T Manuel De L'utilisateur page 33

36YH46000.book 31 ページ ２０１４年８月２８日 木曜日 午前１１時７分
2.Remove any dirt from around the spark plug area.
3.Disconnect the spark plug cap and use the proper size spark plug
wrench to remove the spark plug.
4.Visually inspect the spark plug. Discard the spark plug if there is
apparent wear, or if the insulator is cracked or chipped. Clean the
spark plug with a wire brush if it is to be reused.
5.Measure the plug gap with a feeler gauge.
Correct as necessary by bending the side electrode.
The gap should be:
0.6–0.7 mm (0.024–0.028 in)
SIDE ELECTRODE
SEALING WASHER
SPARK PLUG CAP
SPARK PLUG WRENCH
0.6–0.7 mm
(0.024–0.028 in)
INSULATOR
31