Honda WX10T Manuel De L'utilisateur page 19

36YH46000.book 17 ページ ２０１４年８月２８日 木曜日 午前１１時７分
5.Check that all nuts, bolts, and screws are tightened.
Check for loose bolts, nuts and screws.
Tighten the bolts, nuts and screws properly and securely, if necessary.
6.Check the priming water.
Make sure that the pump chamber is filled with priming water up to its
filling level.
CAUTION:
Never attempt to operate the pump without priming water, or the pump
will overheat. Extended dry operation will destroy the pump seal. If the
unit has been operated dry, stop the engine immediately and allow the
pump to cool before adding priming water.
PRIMING WATER FILLER CAP
WATER
PRIMING WATER 
FILLING LEVEL
17