Startup; Change The Language; Standard Operation; Calibration Settings - Hach sensION+ MM374 Manuel D'utilisation

Figure 4 Single screen display
1 Sample ID
2 Measurement unit and value
(conductivity or ISE)
3 Measurement unit and value (pH,
ORP/mV)
4 Measurement mode or time and
date
Navigation
Use the to return to the previous menu. Use the measure key
take a sample measurement or to confirm options. Use the arrow keys
to scroll to other options or to change a value. To change the
parameters use the arrow keys and . Refer to each task for specific
instructions.

Startup

Turn the meter on and off
N O T I C E
Make sure that the probe is connected to the meter before the meter is turned on.
Push to turn on or turn off the meter. If the meter does not turn on,
make sure that the AC power supply is properly connected to an
electrical outlet.
5 Measurement channel
6 Sample temperature (ºC or ºF)
7 Visual measurement timer
to

Change the language

The display language is selected when the meter is powered on for the
first time.
1. Use the or to select a language from a list.
2. Confirm with . The measurement screen shows DATA OUTPUT.
3. Select Deactivated if no printer or PC is connected and confirm.
Refer to Select the data output
about Data Output.

Standard operation

Calibration
D A N G E R
Chemical exposure hazard. Obey laboratory safety procedures and
wear all of the personal protective equipment appropriate to the
chemicals that are handled. Refer to the current safety data sheets
(MSDS/SDS) for safety protocols.

Calibration settings

The calibration settings contain Calibration type, Calibration frequency
and Display options.
1. From the main menu use the
Confirm.
2. Use the to enter the calibration menu.
3. Use the or to select the following options:
Option Description
Stability C.: Criterion by stability—select Fast, Standard or Strict.
on page 12 for more information
or to select CALIBRATION.
English 9