Installing/Replacing The Lamps - Skytec 151.725 Mode D'emploi

MIRROR BALL
INSTALLATION IN PRIVATE PREMISES
- WARNING: A falling mirror ball can cause serious injuries!
- A mirror ball is meant to create decorative light effects in combination with an appropriate light
source.
- ATTENTION!! Mirror balls need to be installed by a professional according to the European
standard EN60598.
- The installation that supports the mirror ball (including the motor) needs to be able to carry
during 1 hour 5 times the weight of the mirror ball without showing visible distortion.
- Use a chain of sufficient strength to link the motor to the mirror ball. Do not use steel cable
that might fray due to the torsion.
- Big mirror balls need to be secured by a safety net.
- The mounted motor and mirror ball assembly needs to be checked regularly, and at least once
a year by a professional.
- Check regularly the chain between the motor and the mirror ball, including the fixing points on
the motor and the ball.
INSTALLATION IN PUBLIC PREMISES
- WARNING: Mirror balls need to be installed according to the European standard EN60598-2-7
and the standards which are applicable in the different countries. The installation might only
be done by a professional installer!
- The installation that supports the mirror ball (including the motor) needs to be able to carry
during 1 hour 10 times the weight of the mirror ball without showing visible distortion.
- The installation needs to be secured by a safety net so that no parts can fall down.
- IMPORTANT! THE INSTALLATION OF LIGHT EFFECTS REQUIRES EXPERIENCE and
knowledge of load calculations, installation materials, periodic safety checks, etc. Leave the
installation to a professional if you don't have the required knowledge and experience. A
wrong installation might cause serious injuries and material damages.
- Use a chain of sufficient strength for the link between the motor and the mirror ball. Do not use
steel cable that can fray under the torsion.
- DANGER: Prior to the first use of the motor and mirror ball assembly, the installation needs to
be checked by a professional.
- The motor and mirror ball assembly needs to be checked regularly by a professional.
- Check regularly the chain between the motor and the mirror ball, including the fixing points on
the motor and the mirror ball.
PAR36 SPOT WITH COLOUR WHEEL

Installing/replacing the lamps

Before replacing the lamp, unplug mains lead and let the lamp cool down. Please follow the lamp
manufacturer's notes when installing.
- You need one 6V 30W Par 36 Lamp for installation.
- Please remove the fixation ring by pressing it together.
- If replacing the lamp, remove the old lamp from the pin spot and loosen the wires.
- Loosen the screws on the new 6V 30W Par 36 lamp with an appropriate screwdriver.
- Connect the wires with the lamp using an appropriate screwdriver.
- Tighten the screws.
- Insert the lamp in the housing.
- Fix the lamp with the fixation ring.