To Stop The Product; Maintenance - Husqvarna LC 151 Manuel D'utilisation

• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
• Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm.

To stop the product

• To stop the drive only, release the drive bail.
• To stop the engine, release the engine brake handle.
To use the product with the grass
catcher (LC 151, LC 151S)
WARNING: Do not operate the product
without a grass catcher installed or without
the rear cover closed. Objects can eject and
cause injury to the operator.
1. Lift the rear cover and remove the mulch plug if it is
installed. (Fig. 28)
2. Assemble the grass catcher, refer to
the grass catcher (LC 151, LC 151S) on page 10 .
3. Put the grass catcher on the bracket.
4. Release the rear cover and put it on top of the grass
bag frame. (Fig. 29)
To change the product to mulch mode
(LC 151, LC 151S)
Make sure the engine is off before you change the
product to mulch mode.
1. Lift the rear cover and remove the grass catcher, if it
is installed.
2. Put the mulch plug into the discharge channel. (Fig.
30)
3. Close the rear cover and make sure that it is tightly
closed against the mulch plug.
Note: To increase the performance of the mulch mode,
replace the blade with the mulch blade accessory. Refer
To replace the blade on page 13
to
To change the product to side
discharge mode
1. Lift the rear cover and remove the grass bag, if it is
installed.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
1566 - 006 - 11.08.2021
2. Close the rear cover and make sure that it is tightly
3. Lift the discharge lock. (Fig. 31)
4. Open the side discharge cover and install the side
5. Let the side discharge cover close against the side
Note: To increase the performance in side discharge
mode, install the mulch plug. (Fig. 30)
To empty the grass catcher
1. Lift the grass catcher with the frame handle.
To assemble
2. Use the frame handle and the bag handle when you
To get a good result
•
•
•
•
•
•

Maintenance

For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
closed against the product.
discharge deflector onto the support pins. (Fig. 32)
discharge deflector. Make sure that the side
discharge deflector is tightly in position before you
operate the product.
CAUTION: Lift the grass catcher when you
move it to prevent wear.
empty the grass catcher. (Fig. 33)
Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
Do not cut more than ⅓ of the length of the grass.
Use the highest cutting height when you start to cut
the grass. Examine the result and lower the cutting
height to an applicable level. If the grass is very long,
operate slowly and cut 2 times if it is necessary.
Cut in different directions each time to prevent
stripes in the lawn.
Lift the rear cover and remove the grass catcher.
If a mulch plug and a mulch blade are attached,
remove them.
Close the rear cover before you operate the product.
When you operate the product, the cut grass
discharges below the rear cover.
11