Lubrication; Recommended Lubricants; After The First 8 Hours Service - breviglieri Doble Manuel D'utilisation Et D'entretien

Carefully read the warnings and precautions on the lubricant containers.

5.2 LUBRICATION

Lubrication of any machine with parts that turn and/or rub together is a vitally important task for the life and functionality of the
actual machine itself. Lubrication must therefore be carried out systematically and at the required intervals. The frequencies given
refer to machine use in a normal environment. If this machine is used in heavier duty conditions, it must naturally be lubricated
more frequently.
Proceed in the following way to grease the central rotor supports:
▪
With the tractor on flat ground and the hitched machine closed, raise it and place two strong bearing stands under the sides
of the two cultivators.
▪
Rest the machine on the stands, turn off the tractor engine, remove the ignition key and apply the parking brake.
1
6

5.2.1 RECOMMENDED LUBRICANTS

▪
It is advisable to lubricate the overdrive with:
US Steel 224, AGMA 9005-E02, ISO 12925-1 CKC/CKD
▪
For all greasing points, the Manufacturer recommends: LITHIUM GREASE.
When servicing the driveline, strictly comply with the instructions given by the driveline Manufacturer, in the specific operation
and maintenance manual with which each driveline is equipped.

5.2.2 AFTER THE FIRST 8 HOURS SERVICE

Each new machine must be checked after the first 8 hours service. Proceed in the following way:
▪
Check the general condition of the machine
▪
Make sure that all the screws are well tightened
▪
Check the cutting tools for wear and make sure that the bolts that fasten them are well tightened
▪
Check the level of the lubricants
doble - maxi doble
Use oil of the recommended type for topping up and changes.
Keep all lubricants well away from children's reach.
The operator should thoroughly wash himself after using lubricants.
Dispose of used oil in compliance with the anti-pollution laws.
Greasing the central rotor supports is a dangerous operation.
2
1) Carter oil level
2) Carter oil filling cap (2.11 U.S. gal.)
3) Extension oil filling cap (0.4 U.S. gal.)
4) Oil discharge pipe central gearbox
5) Gearbox oil filling cap (1.98 U.S. gal.)
6) Central rotor support oil filling plug (0.13 U.S. gal.)
PAKELO GEARSINT EPN46 oil,
DANGER
DANGER
3
complying with
specifications.
- 35 -
macchine agricole
4
DIN 51517 Part 3 CLP HC,
5