Stopping The Machine; Parking - breviglieri Doble Manuel D'utilisation Et D'entretien

The heads of the bolts that fix the hoe blades must be on the side of the hoe blades themselves while the nut and relative
washer must be on the side of the flange. Comply with the driving torque values (Nm) given in the following table.
If hoe blades/tines are replaced, make sure that the new ones are fitted in the same positions as the old ones.
DRIVING TORQUE VALUE
Screw categories 6.6
M8x1 15
M10x1,25 30
M12x1,25 51
M14x1,5 81
M16x1,5 120
M18x1,5 173
M20x1,5 242
M22x1,5 321
M24x2 411
VERSION WITH BLADES (BK)
The version with blades has a special support rotor with radial blades. This type of machine is particularly suitable for preparing
seed beds on tenacious or difficult soil, or ploughed land. If all, or even only some of the blades are replaced, it is advisable to
remove and remount one blade at a time to avoid positioning errors.
VERSION WITH TINES (SPIKES)
This version is fitted with a special spiked rotor fixed on highly resistant pressed steel supports. Can be equipped with levelling
plates or with rear roller. This machine is suitable for preparing seed beds on tenacious and stony soil.
It is strictly forbidden to clean the machine whilst it is moving if the hoe blades/knives become clogged. First disengage the
PTO, stop the tractor and engage the parking brake. Wait until all moving parts have come to a complete standstill, then
proceed with the cleaning operations with the utmost care.

4.9 STOPPING THE MACHINE

At the end of the job, the operator must:
▪
Disengage the tractor PTO
▪
Lower the machine to the ground
▪
Stop the tractor and engage the parking brake
▪
Make sure that all parts of the machine have come to a standstill
Only after the above mentioned operations have been carried out may the operator leave the tractor unattended.

4.9.1 PARKING

To park the machine and unhitch it from the tractor, the operator must:
▪
Make sure that no one is standing or crossing the place where the machine will be parked
▪
Make sure that the place in which the machine is to be parked is suitable, flat and uncluttered
▪
Drive to the area where the machine is to be unhitched
▪
Brake the tractor
▪
Lower the bearing stands
▪
Completely lower the machine to the ground
▪
Stop the tractor and engage the parking brake
▪
Disconnect the quick couplings
▪
Remove the driveline from the tractor's PTO and rest it on its bracket
doble - maxi doble
8.8 10.9 12.9
26 36 44
52 74 88
91 127 153
143 201 241
214 301 361
308 433 520
431 606 727
571 803 964
731 1028 1234
WARNING
DANGER
- 33 -
macchine agricole