Hand Switch - Beurer MG 200 HD-enjoy Mode D'emploi

hand switch

1
1 ON/OFF button with control LED
2 MASSAGE button with control LEDs
2
3 TIMER button with control LEDs
4 DEMO button
3
4
6. Start-up
CAUTION
• IMPORTANT: Deactivate the transport lock on the massagemechanism before starting-up
for the first time. Remove the screw on the reverse side of the seat cover using the tool sup-
plied. The Shiatsu seat cover will be irreparably damaged and unusable if the transport lock
screw is not removed and the Shiatsu seat cover is operated immediately. No guarantee is
accepted in this case.
• Insert the transport lock screw each time the device is transported again. The device may be ir-
reparably damaged if it is transported without the transport lock.
• Fasten the protective cover to the surface of the Shiatsu seat cover with the Velcro straps. It is also
possible to massage without the protective cover; this is generally found to be "harder".
• Position the seat cover upright on a suitable seating arrangement with seating surface and backrest
(chair, sofa, or similar). Ensure that the seat cover is supported over its entire area and has a suffi-
ciently high backrest.
• Use the flexible fastening straps and Velcro strips to secure the Shiatsu seat cover.
• Connect the device to the mains power supply.
7. Operation
Gently press your back against the massage device to start with. Then make sure that you are in a comfort-
able position before gradually shifting your weight onto the massage device.The massage must be pleasant
and relaxing at all times. Stop the massage or change your position or the contact pressure if you find it is
painful or unpleasant.
• Do not force any part of your body, in particular your fingers, between the rotating massage heads and
their mountings in the device.
• Sit comfortably and upright on the seat cover. Ensure you sit centered and such that the massage heads
can move to the left and right of your spinal column.
• Switch on the massage device with the ON/OFF button. Select the region you wish to massage with the
MASSAGE button.
1. Entire back
2. Lower back
3. Upper back
The LED lamp indicates the massage region set.
• The Shiatsu massage unit with rotating massage heads slowly moves upwards from the starting position
in the lowest region of the back and moves up and down in the massage region set. Application only at a
single point is not possible, as the rotational movement and the displacement up and down are coupled.
• The automatic switch-off function is activated with selection of the massage region and is preset to 15
minutes. You can set the automatic switch-off function to 5, 10 or 15 minutes by pressing the TIMER but-
ton. Please note that changing the timer setting makes the timer start to count again from the beginning.
To avoid overheating the device, select the maximum massage duration at the beginning of the massage
and do not change it again during the massage.
11