Hand Switch; Initial Use; Operation - Beurer MG 320 Mode D'emploi

Hand switch

5 10 15
2
timer
demo
5
neck
7
air seat air back
spot
10
11
full upper
back back
14
intensity
Pantone 冷灰 11C

6. Initial use

Pantone 深灰色
• Position the seat cover upright on a suitable seat with a sitting area and back rest (chair, sofa or similar).
Make sure that the seat has a sufficiently high backrest.
Pantone 白色
• In order to secure the Shiatsu air compression seat cover, use the flexible tie straps and hook and loop
fasteners.
透明孔位
• Connect the device to the mains by plugging the plug into the socket.

7. Operation

At first, press your back only carefully against the massager. Then check carefully whether the massage
position is pleasant for you and then lower your weight gradually towards the massager.
The massage should feel pleasant and relaxing at all times. If the massage is painful or uncomfortable, stop
the massage or change your position or the contact pressure.
• Do not force or jam any part of your body, in particular your fingers, between the rotating massage elements
or their holders in the unit.
• Sit comfortably and upright on the seat cover. Take care to ensure you are positioned in the middle of the
massager and that the massage heads can move to the left and right of your spine.
• Switch on the massager with the
selected.
• Automatic switch-off is automatically activated when the device is switched on and is pre-set to 15 minutes.
By pressing the timer button, you can set the automatic switch-off to 5, 10 or 15 minutes. Please note
that the timer begins to count again when you change the timer setting. In order to prevent overheating
of the device, set the maximum massage period at the beginning of the massage and do not change it
again during the massage.
3
1.
2. Timer button (5 – 10 – 15 minutes)
4
6
3. Demo button
8
4. Neck button
9
5. Neck
6. Neck
7. Air seat button (air compression massage)
8. Air back button (air compression massage)
9. Spot button (spot massage)
12
13
10. Height adjustment button (spot massage)
lower
back
15
11. Full back button (massage for the whole back area)
heat
1 12. Upper back button (massage for the upper back area)
13. Lower back button (massage for the lower back area)
14. Intensity button (massage intensity)
15. Heat button (heating)
button. The LEDs signal the massage functions which are currently
button
button (anti-clockwise rotation)
button (clockwise rotation)
13