Thermador MASTERPIECE Serie Mode D'emploi page 27

Turn off power to the oven at the main power supply
1.
(fuse or breaker box).
2. Remove oven racks if necessary to provide access to
the bulb housing.
3. Optional: remove oven door to provide easier access
and visibility.
4. Insert the tip of a narrow flat blade screwdriver
between the metal clips at about a 40° angle. The
screwdriver blade must be able to pass between the
metal clips to reach the inner catch.
5. (A) Push the screwdriver blade inward to disengage
the catch from the slot in the light housing.
Support the glass lens cover to prevent it from falling.
(B) Gently pry the lens off by moving the screwdriver
6.
handle away from the oven wall. The lens should
detach easily. Do not attempt to force it.
7. Pull the halogen bulb from its socket. If it is difficult to
grasp the bulb using one hand, use both forefingers to
pinch behind the rounded part of the bulb, then pull
the bulb out using both hands.
Replace the halogen bulb. Grasp the new bulb with a
8.
clean, dry cloth. Align the bulb prongs with the socket
holes and press into place.
Direct finger contact with the bulb may cause
premature bulb failure.
Put the glass cover back on by inserting it into the
9.
mounting clip and pressing the end nearest you into
the housing until it locks into place.
10. Turn power back on at the main power supply (fuse or
breaker box).
Removing the Oven Door
CAUTION
9
WHEN REMOVING THE OVEN DOOR:
Make sure oven is cool and power to the oven
▯
has been turned off before removing the door.
Failure to do so could result in electrical shock or
burns.
The oven door is heavy and parts of it are fragile.
▯
Use both hands to remove the oven door. The
door front includes glass components. Handle
carefully to avoid breakage.
Grasp only the sides of the oven door. Do not
▯
grasp the handle as it may swing in your hand
and cause damage or injury.
Failure to grasp the oven door firmly and properly
▯
could result in personal injury or product damage.
To avoid injury from hinge bracket snapping
▯
closed, be sure that both locking levers are
securely in place before removing the door. Also,
do not force the oven door open or closed - the
hinge could be damaged and injury could result.
Do not lay the removed door on sharp or pointed
▯
objects as this could break the glass. Lay the
door on a flat, smooth surface, positioned so that
the door cannot fall over.
To remove the oven door:
Read the preceeding caution notice before beginning
1.
the oven door removal process.
Provide a nearby place to safely lay the door after
2.
removal so it will not fall over or be stepped upon. Lay
the door flat on a blanket or cushioned surface.
Open the oven door fully until it is parallel to the floor.
3.
The door contains powerful springs to assist with
closing the door. It is necessary to position the toggle
locks in place to take the tension off the springs.
27