Installation Instructions; Prepare Location - KitchenAid KVUB406GSS Guide D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

It is recommended that the vent system be installed before

■

the range hood is installed.

Before making cutouts, make sure there is proper clearance

■

within the ceiling or wall for vent fittings.

Making the cutout to the bottom of the cabinet may be

■

easier to do prior to mounting the cabinet to the wall.

1. Disconnect power.

2. Determine which venting method to use: roof, wall, or

non-vented.

3. Select a flat surface for assembling the range hood. Place

covering over that surface.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

range hood.

Failure to do so can result in back or other injury.

4. Using two or more people, lift range hood onto covered

surface.

Range Hood Cabinet Cutout

1. Use a saber saw or keyhole saw to cut out the cabinet

bottom inside the cabinet frame.

NOTE: Frameless type cabinets require 3/4" (19 mm) front lip

in the cabinet bottom. A 3/4" (19 mm) thick filler strip (not

supplied) may be required for some types of cabinets (see

Step 3 in the "Install Range Hood" section).

A. Bottom of cabinet cutout

B. Bottom must be cut flush to the inside walls of the cabinet

C. 10

⁄

" (27.6 cm) min. from the inside of the cabinet front face

D. Min. 3/8 (9.5 mm), max 3/4" (19 mm) thick front face required

for cabinet bottom

E. Front of cabinet

2. Complete cabinet preparation following the instructions for

your type of venting. Determine venting cutout locations and

cut out vent openings in the cabinets, walls, and/or soffit.