General Comments - WOLFF Profi Traduction Du Mode D'emploi Original

5.1 General comments

Turn the circle cutter slowly and exert not much pressure on the blade
"Circle 1" means the circle in the external flooring (drawn
with stripes)
"Circle 2" means the circle in the internal flooring (drawn white)
5.2 Textile floorings
Cut circle 1 and 2 with the circle cutter
5.3 Resilient floorings
a.) Roll material
Scribe the desired radius of circle (1) (drawn with stripes)
and cut circle with a knife with hooked blade
Scribe circle (2) in new flooring (radius approx. 2 cm larger)
and cut circle with knife with hooked blade
centre circle (2) into circle (1), so that circle (2) overlaps
(as shown in picture 1)
scribe circle (2) with a scriber and cut it with a knife rub the
seam with a flooring roller
b.) Tiles
lay out the tiles for the external circle and fix them on double-
sided tape
scribe the external circle with the circle cutter
remove scribed tiles individually and cut them with a knife
and re-insert each tile at once
lay out the tiles for the internal circle, cut the tiles so that
they overlay the external circle approx. 2 cm
scribe each tiles with a scriber, cut it with a knife and
re-insert it at once
if all tiles are cut correctly, remove the double-sided tape.
Bond tiles with adhesive and rub them with a flooring roller.
5.4 Parquet and laminate
The circle cutter has to be connected with a standard milling
machine for milling circles in parquet and laminate. To connect
the milling machine, the Adapter for milling machine, # 015627,
is necessary. Using a milling machine with milling cutter, a circle
is milled with the circle cutter.
For floating installalion of parquet we recommend the following
methods: (If the parquet is bonded all-over, mill the circle without
the "step".)
mill a "step" into the external circle, the internal circle is laid
into the step
always mill a step of 1/2 of the depth (1/2 of the parquet
thickness)
use a milling cutter with 5 mm diameter (thus you calculate
the step much easier)
always use a base when milling to protect the ground or
the floor
Kreisschneider Profi, #015626
1
2
9