First Time Installation - Xoro HTL 2335HD Mode D'emploi

When you start the TV set the first time and choose TV or DTV, than appears the installation guide on
the screen. With this guide you can search analogue and digital TV channels. The search routine
includes the frequencies of the analogue and digital broadcaster.
1. Please select the OSD language. You can
choose the pre-installed languages by
pressing the ◄ or ► buttons. If you find
your languages,
language by pressing the OK button.
2. Press the ▼ button and navigate to the
option „Auto Scan". The search starts
when you press the ► button.
3. A new popup window appears on the
screen. There you can see the option
country selection. Please choose the
suitable country by pressing the ◄ or ►
buttons.
4. If you had chosen the country, please
select the tune type. The options are
ATV+DTV, DTV and so on. If you can
receive only DTV, please choose DTV.
The search runs is faster.
5. After chosen the two options please press
the ▼ button, so that the „Start" field will
be marked with blue and is active. Press
the OK button and the search starts
immediately.
6. A new window opens on the screen, where
the status of the searching is documented. The
values of the found TV broadcast stations of
analogue, digital and Radio are listed.
7. After finishing of the searching, all found TV
broadcast station will be saved into the channel
list. You can load at the TV channel list by
pressing the CH/LIST button.
Note:
The complete searching needs a couple of minutes.

First Time Installation

please confirm the
HTL 2335HD
21