Zodiac X7 Quattro Notice De Montage Et D'utilisation page 18

Notice X7 ANG 2010.qxd 12/07/10
Figure 8
Figure 9
Figure 10
10:32 Page 7
1 8
Connect the male part of the hose adaptor to the leaf trap.
Check that there is no air in the hose assembly, then connect it to
the vacuum point by joining the last hose section to the female
part of the hose adaptor
Connection to the vacuum point
Connection to the skimmer
If you choose to connect to the skimmer, first place the protection
mesh on the first section of pipework.
This will prevent wear due to friction against the skimmer mouth.
(Figure 8).
NOTA: If your pool is fitted with two
skimmers, connect the device to the
skimmer situated in the main pool.
Check that there is no air in the hose
assembly before connecting it to the
skimmer.
Figure 10
Example with the connection to
the vaccuum point