BH FITNESS YF920 Instructions De Montage Et Utilisation page 13

Then take the rear stabiliser bar (14)
and carry out the same assembly
operation as with the front stabiliser bar,
tighten up all of the nuts (11) securely.
4. ATTACHING THE SADDLE.-
Remove screws (19) and washers
(20) from the bottom of the saddle
(21). Fit the saddle in the direction of
the arrow, Fig.4, onto the saddle post
plate (18), making sure that the holes
in the saddle post are facing the front
part of the saddle, and tighten the nuts
securely.
5. FITTING THE BACKREST
SUPPORT.-
Position de backrest "U" (22) in the
saddle post (18) Fig.5, fit the screws
(29) with the washers (20) and tighten
with the nuts (19).
6. FITTING THE BACKREST.-
Position the backrest (26) in the
support (25) Fig.6.
Fit it with the screws (27) and washers
(6) Fig.6.
7. FITTING THE SADDLE
HANDGRIP.-
Position the handgrip (17) in the
support (22) Fig.7. Insert the screws
(3), along with washers (6) and nuts
(20) and tighten securely.
Fit the saddle post plate (18) onto the
handle bar stem (8) and fix its position
with the handgrip (17) Fig. 8.
8. FITTING THE HANDLEBAR.-
Bring the handlebar (2) up to the
handlebar stem (8), slot as shown in
Fig.9, refit the screws (5), the washers
(6) and (7),
securely. Fit the console (1).
9. ATTACHING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the
letter, fitting these incorrectly could
damage the screw thread on the
pedal or the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right pedal (9) is marked with the
letter (R).This screws onto the right-
hand crank, also marked with an (R),
in a clockwise direction. Tighten
securely Fig.10.
The left pedal (16) is marked with the
letter (L).This screws onto the left-
hand crank, also marked with an (L),
in an anti-clockwise direction.
Tighten securely Fig.10.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
13
Fig.9, and tighten