Maxspect R420R 160w Mode D'emploi page 13

Automatic Mode "A"
Under the Automatic mode, users can program their own photo-period profile using 6
Time-Points.
Understanding Time Points
There are a total of 6 Time Points. You can program different luminous output intensity at each
Time Point to control the photoperiod and brightness of the system.
For example, the following table demonstrates how you could program the Time Points such
that the system would increases light gradually from 8:00am, peaks at 10:00am-2:00pm then
slowly decreases light until it is turned off at 10:00pm.
TP1
08:00
Channel A OFF
Channel B OFF
The following diagram would illustrate how the 2 LED channels would behave once the above
Time Points have been programmed.
100%
50%
0%
Setting up Moon Light
Moon-Light can be programmed by simply assign one of the LED channels (preferably the blue
LED channel) to operate at 1% brightness in the last Time Point.
TP1
08:00
Channel A OFF
Channel B
TP2 TP3
09:00 10:00
50% 100%
50% 100%
TP2 TP3
10:00 14:00
50% 100%
1% 50% 100%
Operating Instructions
TP4 TP5
14:00 18:00
100% 50%
100% 50%
TP4 TP5
22:00 18:00
100% 50%
100% 50%
TP6
22:00
OFF
OFF
Channel A
Channel B
TP6
22:00
OFF
1%
12
English