Delta 32-325 Manuel D'utilisation page 9

ATTACHING THE FENCE TO THE MACHINE
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs� An accidental start-up can cause injury.
1. Place the spacer (A) Fig. 9 over the hole (B) in the
table bracket with the large countersunk end of the
spacer (A) in the "up" position.
2. Place a 1/4" lockwasher (C) Fig. 9 and a 1/4" flat
washer (D) on the 1/4-20 x 1-1/2" (38.1 mm) hex
head screw (E). Insert the screw (E) up through the
hole (B) in the table bracket and through the hole in
the spacer (A). Thread the screw (E) into the
threaded hole (F) on the bottom of the fence.
NOTE: Loosely tighten the hardware for further
adjustment.
3. Attach the remaining spacer to the opposite end of
fence in the same manner.
4. The fence (G), attached to the table bracket, is
shown in Fig. 10.
NOTE: Loosely tighten the two screws, one of which is
shown at (E) for further adjustment.
ALIGNING THE FENCE PARALLEL TO THE LINE BORING HEAD
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs� An accidental start-up can cause injury.
NOTE: Refer to Setting The Fence Stops in the Operation section of this manual.
1. Set the right fence stop to 9" (229 mm) on the fence scale. Move the left fence stop beyond the 9" (229 mm) mark.
Position the gauge (A) Fig. 11 on the table with the points of both of the indexing pins (B) over the holes (C) in the
gauge.
2. Unscrew and remove the knobs (D) Fig. 11 from the top of the indexing pins.
3. Lower the indexing pins (B) Fig. 12 until the points of the indexing pins engage the two holes in the gauge (A).
Fig� 11
D
B
A
C
F
D
C
G
9
A
E
B
E
B
A
Fig� 9
Fig� 10
Fig� 12