Delta 32-325 Manuel D'utilisation page 8

ATTACHING THE TABLE
TO THE MACHINE
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs� An accidental start-up can cause injury.
1. Clip the two table slides (A) Fig. 3 in the table
bracket (B).
2. Clip the remaining two table slides in the other table
bracket.
3. Center the table (C) Fig. 4 on the machine frame.
4. Position the table bracket (B) Fig. 5 against the
machine frame (D) and underneath the table (C).
Align the two holes (E) Fig. 6 in the table with the
two holes (F) Fig. 5 on top of table bracket (B)
Fig. 5.
5. Fasten the table to the table bracket using the two
1/4-20 x 1-1/4" (31.8 mm) flat head screws (E) Fig. 6,
and two 1/4-20 lock nuts (F) Fig. 5.
NOTE: Loosely tighten the hardware for further
adjustment.
6. Attach the remaining table bracket to the other side
of the table and frame in the same manner.
7. Insert the 5/16-18 x 3/4" (19 mm) carriage bolt (G)
Fig. 7, up through square hole (H) and slot (J).
Secure the carriage bolt using the 5/16" flat washer
(K) Fig. 8 and lock knob (L).
NOTE: Loosely tighten the hardware for further
adjustment.
8. Attach the remaining lock knob to the other side of
the table in the same manner.
B
A
Fig� 3
H
j
G
Fig� 7
C
F
K
8
C
B
E
L
Fig� 4
D
Fig� 5
Fig� 6
Fig� 8