Delta 32-325 Manuel D'utilisation page 10

B
A
G
Fig� 13
4. With the index pins (B) Fig. 13 engaged in the gauge holes (A), loosen the table lock knobs, one of which is shown
at (E). Move the table until the front of the fence (F) is approximately 1/32" (0.8 mm) away from the gauge at point
(G) on each end of the gauge. Tighten the table lock knobs (E).
5. Use a small "C" clamp (not supplied) to secure the table bracket (K) Fig. 13 to the machine frame (L) at a point
between the two slides to avoid move ment. Clamp the table bracket on the other side of the machine to the
machine frame in the same manner.
6. Loosen the two screws (E) Fig. 10 that fasten the fence (F) Fig. 14 to the machine. Move the fence (F) until the
front surface of the fence contacts the gauge at point (G) on each end of the gauge. Move the fence left or right
until the right fence stop (set in STEP 1 - see inset - Fig. 14) contacts the gauge at point (H) Fig. 14. Tighten the
fence mount ing hardware.
NOTE: The fence stop was removed for clarity�
Refer to the following instructions Adjusting The Ta ble Parallel To The Fence�
7.
ADjUSTING THE TABLE PARALLEL TO THE FENCE
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs� An accidental start-up can cause injury.
1. Remove the gauge (A) Fig. 11. The points of the index pins (B) Fig. 15 should point to the 2-1/4" mark on both
scales.
2. If an adjustment is necessary, loosen the four screws (C) Fig. 15 that fasten the table to the machine frame. Adjust
the table until the index pins (B) point to the 2-1/4" mark on scales (A). IMPORTANT: Make sure that the table
mounting brackets are held securely against the machine frame and tighten four screws (C).
3. Replace the knobs (D) Fig. 16 on top of the indexing pins (B).
NOTE: The space between the rear of the table and the front of the fence is for chip removal.
4. Remove two clamps temporarily attached in STEP 5 of section Aligning The Fence Parallel To The Line Bor ing
Head�
A
Fig� 15
E
K
F
B
C
A
L
Fig� 14
Fig� 16
10
F
H
G
D
B